For 5.7 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module PFXZGECLUSA1 PFXZGECLUSA1 12.1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).10.4 inches (TFT), the GP will be installed to the hard panel to provide dust and moisture proof function.5 / setsFor the operation screen (5 pieces) (GP3000H standard) PFXZGECLUSA1. The MITSUBISHI A series PLC is connected to GP, length: 5 m.Adapter for EX module (5 / set)COM1 interface with the cable for direct connection to the CPU series PLC QPortable GP2000H series models accessories, RS-422 single head cable (3 m).For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters.13 pin input connectors for HTB and 16 pin output connectors PFXZGECLUSA1. (1 / set)For connecting the GP3000H cable connector and the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block.The host controller is connected to the host computer interface, which is used for multiple connection (n:1) communication.With the installation of screws (4 / sets), for the GP4000 series back mounted to the fixed panel models. (2 / set)When the man-machine interface is installed to the fixed panel to provide dust proof andd moisture proof function PFXZGECLUSA1. (1)The man-machine interface directly connected MITSUBISHI electric PLC Q series CPU programming port.Used to prevent disconnection. (1 interface, 5 / set)Used to connect the GP2000H series RS-232C conversion adapter with GP3000H, with D-Sub connectors PFXZGECLUSA1.
Length: 3 meters. Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.