For connecting the GP3000H cable connector and the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block.The main controller is connected to the man-machine interface of the host, for MPI communicationFor the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 5 meters PFXZCBADTM1 PFXZCBADTM1 10.4 inch screen protective cover (1 pieces)Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).Cable for connecting GP3000 to various modules2 / setsOne end is a loose wire, which is used to carry out RS-485 connection between the host and LT.With the installation of screws (4 / sets), for the GP4000 series back mounted to the fixed panel models PFXZCBADTM1. (2 / set)For thin film surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)5 / setsDisposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceLT4000M (module type analog), NPN output, DC24V (host).Used to output the image signal from the host computer to GPLT4000M (module type DIO), PNP output, DC24V (host) PFXZCBADTM1. A veneer, for the GP4000 series back loading models of full flush (white, 1)For the direct connection of the MITSUBISHI A series CPU PLC (not to be used at the same time, the programmer) length: 5 meters.COM2 adapter for converting the COM2 interface to the RS-422 terminal blockConverting 2 analog signals into digital signalsDisposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceTouch screenn anti ultraviolet protective film (1 pieces) PFXZCBADTM1. Touch screen anti ultraviolet protective film (1 pieces).Used to connect the GP2000H series RS-232C conversion adapter with GP3000H, with D-Sub connectors.
Length: 3 meters. 12.1 inches, repllaced by a host of backlight (1) PFXZCBADTM1. Adapter for EX module (5 / set)Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.