COM2 terminal adapter for communication through the RS-422/485 connectionCable for connecting GP3000 to various modulesScreen protection cover (1 pieces) for protecting screen against pollution of man-machine interfaceThe module is used for mounting on the back board of the GLC2000 series host computer GP230-IS11-O. Then you can install the GP77R series or GLC100 series of medium size expansion module in the module on the outward side GP230-IS11-O15 inches, GP installed to the hard panel to provide dust and moisture proof function.COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)LT fasteners installed on the control panel (4 / set)COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)LT4000M (module type DIO), NPN output, DC24V (host) GP230-IS11-O. Portable GP2000H series models accessories, RS-422 cable with D-Sub connector (10 meters).7.4 inches or larger, for external reset input, NETWORK FLEX communication, audio output. AUX connector, L typeUsed to convert RGB to DVI-AConnect to USB printer (Type-B) GP230-IS11-O. 512MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.LT4000M (module type analog), PNP output, DC24V (host).For the operation screen (5 pieces) (GP3000H standard).The installation of accessories, adjust the size of the GP-411xT panel with the same size of the GP-410xG/W, easy to replace.For 3.8 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)Screen protection cover (1 pieces) for prrotecting screen against pollution of man-machine interfaceTouch screen anti ultraviolet protective film (1 pieces) GP230-IS11-O. Used to install the human machine interface to the fixed panel (2 / cover).Portable GP2000H series models accessories, RRS-422 single head cable (10 m) GP230-IS11-O. COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connector