10.4 inch screen protective cover (1 pieces)The main controller is connected to the man-machine interface of the host, for MPI communicationCable for connecting GP3000 to various modules(serial communication terminal adapter is included in the product package)COM1 interface with the cable for direct connection to the CPU series PLC AMounting screws (4 sets) to be fitted to the hard panel at the interface of the machine FP-DV01-50 FP-DV01-50 Extension cable for connecting USB (Type-A) interface to front panel.5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).GLC2300 is not availableTouch screen anti ultraviolet protective film (1 pieces) FP-DV01-50. 7.4 inches, replace the backlight (1 / set)10.4 inches (TFT), for the protection of the man-machine interface from oil and chemical pollution (5 / set).The MITSUBISHI Q series PLC is connected to GP, length: 5 m.For connecting the GP3000H cable connector and the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block FP-DV01-50. Connector for connecting DC power cord (5 / set).The PC adapter for PCMCIA slot read CF card required.7.5 inches, GP installed to the hard panel to provide dust and moisture proof function.Data transmission cable between host and LT series. Length: 5 meters.Suitable for LT4000M/GP4000M series modules, 5.7 inch. When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function. (1)Used in a variety of host and man-machine interface for RS-422 connectionFor 5.7 inch models, connect the connector to the DIO interface. For connecting external I/O devicces FP-DV01-50. (5 / set)NETWORK FLEX 64 point DIO connector terminal block, (including 2)Expansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master stationPortable GP2000H series models accessories, RS-422 single head cable (3 m) FP-DV01-50. COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connector