Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2256MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.For 5.7 inch models, for fixing the hooks of the three EX modules CA4-DCMDL-01 User's Manual. Expansion module for the GP3000 access to the CANopen network and communication with the CANopen master stationFitting on NETWORK FLEX interface CA4-DCMDL-01 Connecting NETWORK FLEX communication cable. (5 / set)COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)Extended cable for connecting USB (Type-A) (LT) interface CA4-DCMDL-01 User's Manual. COM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interfaceCOM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connectionExpansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master stationUsed to convert the USB interface to the serial interface (RS-232C). A modem or bar code reader that can be connected to support RS-232C CA4-DCMDL-01 User's Manual. COM2 adapter for converting the COM2 interface to the RS-422 terminal block2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set).For RGB input USB cable to prevent disconnection (2 / set)12 CA4-DCMDL-01 Manual. 1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).The main controller is connected to the host computter interface (can be switched between RS-232C and RS-422) using the isolation module CA4-DCMDL-01 Manual. USB cable to prevent disconnection of the fastening clip (5 / set)