GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panel10.4 inches (TFT), the replacement of the host backlight (1).COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communication12 CA3-ISO485-01 User's Manual. 1 inch /10 CA3-ISO485-014 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set).12.1 inches, replaced by a host of backlight (1).COM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interface2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA3-ISO485-01 User's Manual. COM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connectionExpansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master station13 pin input connectors for HTB and 16 pin output connectors CA3-ISO485-01 User's Manual. (1 / set)A connector that connects the DIO interface for connecting an external I/O device (5 sets).5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).Used to convert RGB to DVI-A7.5 inches /3.8 inches /5.7 inches, used to connect the power cord (5 / sets).10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the rrequired accessories CA3-ISO485-01 Manual. Adapter for EX module (5 / set)Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2Fitting on NETWORK FLEX interface. Connecting NETWORK FLEX communication cable. (55 / set)Extension cable for connecting USB (Type-A) interface to front panel CA3-ISO485-01 Manual. COM1 interface with the cable for direct connection to the CPU series PLC Q