10.4 inches (TFT), the replacement of the host backlight (1).For the operation screen (5 pieces) (GP3000H standard).Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communication10.4 inches (TFT), the replacement of the host backlight (1).COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)12 CA3-DFS15-01 User's Manual CA3-DFS15-01 1 inches, replaced by a host of backlight (1).Protection for GP rear connectors (large and small for each of the 1).5.7 inches, GP installed to the hard panel to provide dust and moisture proof function.COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)Adapter for EX module (5 / set)Fitting on NETWORK FLEX interface CA3-DFS15-01 User's Manual. Connecting NETWORK FLEX communication cable. (5 / set)Engineering documents created by the LT interface to download images and logic programming software through the USB interface.Adapter for EX module (5 / set)For 5.7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening CA3-DFS15-01 User's Manual. 10.4 inches (TFT), the GP will be installed to the hard panel to provide dust and moisture proof function.Use external output for the GP3000 series of auxiliary connectors (5 / sets).12.1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).COM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connection13 pin input connectors for HTB and 16 pin output connectors. CA3-DFS15-01 Manual. (1 / set)Used to connect the SIEMENS S5 PLC series to the host computer interfaceGP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelExtension cable for connecting USB (Type-A) interface to front panel CA3-DFS15-01 Manual. The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.